QUICK DIE CHANGE SYSTEM

快速换模的好处

BEFORE AFTER IMPORTING QUICK DIE CHANGE

BEFORE

Manual Operation

While Die/Mold changing, it takes long time and manpower to tighten.

The tightening force will be different by different operators.

Operators waste much manpower, increased injury happened.

No alarm notification while the screws are loosing.

AFTER

Automation

Only touch the buttons on the control panel.

The clamping force is the same. Increased safety.

By control panel, operators save manpower and decrease injury happened.

With alarm device, the machine will stop immediately.

COMMERCIAL BENEFITS OF IMPORTING QUICK DIE CHANGE

DIRECT BENEFITS

Reduce die/Mold change tim

Multiple small quantities

Reduce inventory

Quality improvement

Reduce labor costs

INDIRECT BENEFITS

Dies Standardization

Press Standardization

Increasing Operational Safety

Achieve rapid production and marketing

Improving factory environment

SYSTEM SelectION

Our company can adapt to the user's habits and tailor the most suitable quick changeover system and fully automatic die change trolley system according to customer needs to help you complete intelligent manufacturing.

AIR DRIVEN HYDRAULIC PUMP UNIT MODEL SelectION
SelectION OF DIE CLAMPS
SelectION OF DIE LIFTER
SelectION OF DIE ARMS

>> Basic type selection		>> Clamp clamping force calculation		>> Upper and lower molds		>> Number of clamps
There is a "U" groove design on the edge of the mold, using the TX type No "U" groove design on the edge of the mold, using TY type		Clamp total clamping force = punching capacity 20%		(Upper mold clamping force): (lower mold clamping force) = 3:2 (single clamp clamping force) = (upper or lower die clamping force) / number of clamps		Depending on the size of the mold and the tonnage of the punch output

Bolt specification	M16	M18	M20	M24	M30	M38
Clamping force	4	4	6	10	16	20

* The clamping force of the upper clamp should be corrected according to the actual operation, and the thickness of the clamping die must be standardized to facilitate the use of the clamp.

>> 选用参考基准

依据冲床吨位选择DL型(油压型)或DR型(弹簧式)，此外并需将模具重量与所需举模器之长度一并考量

>> 选用参考基准

· 举模器长度 · 最大承载重量
· 配管配件 · 举模能力
· U槽尺寸

>> Reference reference
· Mold size · Molding arm maximum load weight · Type

CASE VIDEO